SRc5P Dual Channel Slot Mount Receiver

<Frequency Selection Steps> Selectable; 100 kHz or 25 kHz </Frequency Selection Steps> <Receiver Type> Dual conversion, superheterodyne </Receiver Type> <IR Frequencies> Ch.1: 248.450 MHz and 350.000 kHz, Ch. 2: 243.950 MHz and 250.000 kHz </IR Frequencies> <Frequency Stability> ±0.001 % </Frequency Stability> <Front End Bandwidth> 20 MHz @ -3 dB </Front End Bandwidth> <Sensitivity> 1.0 uV (-107 dBm), A weighted, 2.2 uV (-100 dBm), A weighted </Sensitivity> <Squelch Quieting> Greater than 100 dB typical </Squelch Quieting> <AM Rejection> Greater than 60 dB, 4 uV to 1 Volt </AM Rejection> <Modulation Acceptance> 85 kHz </Modulation Acceptance> <Image And Spurious Rejection> 85 dB </Image And Spurious Rejection> <Third Order Intercept> 0 dBm </Third Order Intercept> <Diversity Method> SmartDiversityTM phased antenna combining or Ratio Diversity using both receivers for a single audio channel </Diversity Method> <FM Detector> Digital Pulse Counting Detector operating at 250 and 350 kHz </FM Detector> <RF Spectrum Analyzer> Coarse and fine scanning modes for RF spectrum site survey </RF Spectrum Analyzer> <Antenna Inputs> 50 Ohm; SMA female connectors </Antenna Inputs> <Audio Output Connectors> Interchangeable D connector adapters for camera slot interfaces; Dual TA3 male (mini XLR) balanced output adapter; Balanced output adapter with fixed cables </Audio Output Connectors> <Front Panel Audio Output (5p Model)> Control panel TA5M with two balanced outputs </Front Panel Audio Output (5p Model)> <Audio Output Level> Adjustable -50 to +5 dBu in 1 dB steps; unbalanced output is 6 dB lower </Audio Output Level> <Audio Channel Crosstalk> -80 dB or better </Audio Channel Crosstalk> <Front Panel Controls And Indicators> Sealed panel with membrane switches; LCD monitors pilot tone; antenna phase, receiver battery level; transmitter battery status; audio level, RF level </Front Panel Controls And Indicators> <Audio Test Tone> 1 kHz, -50 dBu to +5 dBu output (bal); 1% THD </Audio Test Tone> <Transmitter Battery Type Selection> 9V alkaline, 9V lithium, AA alkaline, AA lithium, NiMH </Transmitter Battery Type Selection> <Phase Invert> Audio output phase normal or inverted </Phase Invert> <Compatibility Modes> "NA HYBR: North American Digital Hybrid Wireless® MODE 3: Other manufacturer* 200 SER: 200 Series transmitters 100 SER: 100 Series transmitters MODE E: Other manufacturer* EU HYBR: European Digital Hybrid Wireless® 300 SER: 300 Series transmitters (European) MODE 7: Other manufacturer* MODE 6: Other manufacturer* IFB SER: IFB transmitters in IFB mode" </Compatibility Modes> <Smartnr (noise Reduction)> OFF, NORMAL, FULL modes (available in Digital Hybrid mode only) </Smartnr (noise Reduction)> <Frequency Response> 32 Hz to 20 kHz (+/- 1dB) </Frequency Response> <THD> 0.15% (system) typical in Digital Hybrid </THD> <Rear Panel Controls And Features> Audio output connectors; External DC input; </Rear Panel Controls And Features> <Powering And Current Consumption> Min. 7 V to max. 18 Volts DC; 2.6 W; 145 mA at 18 VDC; 290 mA at 7 VDC </Powering And Current Consumption> <Runtime With Srbattsled Adapter> 7.2 V, 2200 mAH “L” style battery will typically provide over 7 hours of operation </Runtime With Srbattsled Adapter> <Transmitter Battery Level Tracking> LCD display with battery icon or timer readout </Transmitter Battery Level Tracking> <Operating Temperature> -20°C to +50°C </Operating Temperature> <Weight> 225 grams (7.9 ozs.) with SREXT adapter </Weight> <Overall Dimensions(with Srext Adapter)> 2.92” wide x 1.22” high x 4.93” deep </Overall Dimensions(with Srext Adapter)>