Please check the item status before ordering or contact us if you need something in a timely manner.
Close Announcement
Empty
Screw-on adaptor for threaded 1/8" jacks.
XLR to lavalier adaptor for microphones wired for Sennheiser SK (2-wire only), Lectrosonics SSM, Audio Ltd., Zaxcom TRX, Wisycom MTP (2-wire only)
Phantom 48 volts/electret converter with 3.5 mm jack.
Phantom 48 volts/electret converter with TA5M connector.
Set of two extenders (3 and 4.5 cm) compatible with current Sennheiser handheld transmitters to allow mic flag or large custom windshield use.
Converts the Lightning jack of any Apple device that runs iOS 9 or later into a 3.5mm (1/8") AUX port and a charge port
Adapts a Lemo 3-pin lavalier connector (e.g. older Sennheiser wireless, Zaxcom, and Wisycom tx) to 3.5mm (1/8") for use with the Sennheiser G3 and AVX tx.
Converts Countryman B6 wired with a threaded connector to specified wireless transmitter. Select tx make/model from dropdown.
Allows Wisycom wireless with 1-pin Lemo antenna connectors to use external BNC antennas.
Converts DPA lavalier wired for Microdot adapter to specified wireless transmitter. Select tx make/model from dropdown.
Turnaround for USB connector.
Allows easy access to jacks with minimal clearance.
Two-pack of turnaround barrels for RCA stereo cables.
Adapts a Lemo 3-pin lavalier connector (e.g. older Sennheiser wireless, Zaxcom, and Wisycom tx) to 3.5mm for use with the Sennheiser G3 and AVX tx.
Adapts a Lemo 3-pin lavalier connector (e.g. older Sennheiser wireless, Zaxcom, and Wisycom tx) to TA5F for use with Lectrosonics tx.
Polarity-reversing XLR barrel adapter for correcting current draw in some P48 powered condenser mics with HM or UH400a/TM.
etherCON RJ45 feedthrough coupler for Cat5 cable extension.
Converts Point Source Audio X-Connectors to selected wireless transmitter.
Allows 12T microphones to operate with 48V phantom power.
Provides transformer isolation between equipment.
Attenuates line level signals by 50dB to provide mic level output.
Helps eliminate out of band signals for improved dynamic range and reduced noise and interference;
Single channel inline XLR3 preamp for dynamic and ribbon microphones.
No connectors. Requires soldering.
Can be set to 15, 20, or 25 dB. Passes phantom power
Used to connect balanced and unbalanced devices having different signal levels or impedances.
Helps to eliminate electrical and mechanical noise in an audio system such as 60Hz electrical hum from AC power lines, low-frequency rumble caused by wind noise or air conditioning system, and stage/floor noise transmitted to a microphone through the microphone stand
Converts balanced line level signals to microphone level (50dB attenuation)
Reverses the phase (polarity) of a balanced audio signal. In line switch permits selection of normal or reversed polarity for comparison purposes.
RF filter, XLR in/out. Passes phantom power